Pieces of stopper in gear

[ALIN]

20g pin? DAMN! Just drill a hole in your thigh and pour it in!

Use a 25g...your 20g is causing the chunks. Just heat up your gear and it will draw just fine. Less pain shooting too.

that 20g pin is tearing the stopper apart.

 

[enacer420nj]

I'd just stick to a 25 guage tod draw I man you say this keeps happening so just stop drwing it out with a 20 guage and if you do geta piece of a stopper in the bottle just try to draw it out with a needle than discard the needle with the stooper chunk in it better than accidentaly injecting it.

25 to draw? lol you will be there all day not to mention the air bubbles...20 gauge is the way to go

 

[ruthlezz_1]

I have always used 20g to draw, makes it quick and easy. I agree that the stopper may be of poor quality as it is part of a tren kit. Also the bottle is 100cc with 60cc of gear in it. Doing ED or EOD injections puts that much more wear and tear on the stopper. Like I said before, I am just being careful not to draw out any pieces. When I get down to ~10cc's left I will just give the rest to someone. LOL

 

[halfcenturian]

25 to draw? lol you will be there all day not to mention the air bubbles...20 gauge is the way to go

I can heat up gear and draw 1 ml of test cyp in less then a minute.
IN A 25g PIN... Air Bubbles...DOOOOOOD.... PA-LEEZ!

You still having anxiety flashbacks and shit or are your on the piece or what?
I don't know anybody that shoots with a 20g pin.