Shoulder shot?? and oil comes out after shooting WTF!!

[swordfish151]

I'm only using 1cc, I'm using a 21 gauge 1.5 but ofcourse I dont stick the whole 1.5 inches in there only about half or less. I'm going to consider into account and leave the needle there for about 30 to 40 seconds. And wow 4 cc's in th e delts you must have some huge delts! to handle that.

Stick the whole needle in bro..i use 23G 1.5 (sustanon) on my delts and go all the way in...

 

[210toosmall]

Stick the whole needle in bro..i use 23G 1.5 (sustanon) on my delts and go all the way in...

unless you have some pretty impressive delts,
a 1.5 inch pin will put that shit in your bursa! ouch!

 

[DannoMight]

this happens to me sometimes on my delts. its usually a slight mix of oil and blood. I fugured it might be some of the oil that i use to lube my needle before shooting.

 

[c3bodybuilding]

I used to shoot up to 3.5-4 cc's at a time in my delts, and the only time I've had anything like that happen, is when I used 1inch pins. When I would use a 1 1/2 inch pin, it would all stay in.

 

[monopoly19]

Holy cow! 4cc per delt, that's crazy! 1.5in seems deep to me too, but that's prob cause I have little shoulders.

I would also try 25 gauge 1in or 1.5in for delts, less pain, less scar tissue, and injection time is slower so it should spread out a little more in there. Hope some of this helps.

Monopoly

 

[gtrcivic]

if you are poking less than 1/2 of a 1.5 inch needle, really not that deep enough...there's your problem

 

[bigtravis]

its natural. just get some bread and sop it up.

 

[PolfaJelfa]

5/8 inch is more than enough...1 is definately enough. The problem is with your shot placement. Your shooting in the wrong spot. And on the safe side i always leave it in there for 10 or so seconds after. Also immediately after i have something ready to apply pressure with. I have had this also in shoulder when begining.

To recap. Slightly move your location to the meat spot. Go max 1" and. And leave the pin in 10-15 sec. Slowly pull out and then applying pressure. Wait 20 seconds and you sould be golden!

 

[Dieselgoku23]

Thanx bros for the response. I did today and leaving the needle there for 30 seconds and chilled really helped a ton!!! barely nothing came out I put preasure on it with a cotton ball and everything was good. And thanx for your response Polfa really helped Karma your way

 

[PolfaJelfa]

no prob bro