Is this normal to have little pellets left after an hour or so in the solution...There is an orange layer on top, a yellow layer, adn a layer of small undesolved pellets at the bottom...does anyone know?
i set my solution in warm water, it helps to dissolve the pellets , especially if you did not crush them befor hand. try and heat the solution and swirl the vial and they should melt.
hey I'm no vet but, from what I read, you should not leave the pellets in the solution for over an hour. If so the glues will begin to oxidize. And then you will have to heat it back up and prefilter using the serile coffee filter
chek out Mr.H site it will give complete directions
I have a filter for the end of the pin, and I have it from an expert that with the new kits it is no worry to leave in for more than an hour Thanks for the concern...