Shoulder shot?? and oil comes out after shooting WTF!!

[Dieselgoku23]

Hey Bros I have been doing ED Tren Shots anyhow the only places I can take are in my Shoulders and Glute anywhere else I get extremely sore. Anyhow my shoulders are very lean and tight every time I shoot the delts usually the middle head everything goes smooth but when I take out the needle some oil comes out actually maybe 1/4 of a CC or more. This is pissing me off because I dont want to waste my gear lol. Any one can give me an idea to avoid this. Thanx for your response!!

 

[BIGPAPA511]

I have had that happen alot. I don't know if it is a presure build up from injecting or what not a big deal though. I just put my finger over the little hole were I pulled the needle out and massage it for about ten seconds and no problem. I know what you mean you start to freek out when that happens it's like you are looseing your magic potion.

 

[Dieselgoku23]

hahaha exactly bro!!! pisses me off only happens on my shoulders though!!

 

[bilter]

how deep u goin? How many cc? When I do delt injects I push it in real slow then leave the pin there for 30-45 sec after I'm done. Then I do like BP511 suggests. Oh yah, I only do 2cc at most in delts ( I realize you are probably only takin 1) and I use a 1" pin (actually a 1 1/2 I just don't push it in all the way)

 

[monopoly19]

Wow, 2cc's in the delt? I don't usually push 2cc's in my ass. Is there anyone else that's pushing that much into a delt? And for the original poster, sorry bro, can't help ya. Don't know how much your pushin, but I'd say lower it if it's over 1cc.

Monopoly

 

[Baywatch69]

Leave the pin in for around 20seconds after you have pushed all the oil through..

 

[swordfish151]

After injecting just let it chill for a moment, then quickly after apply pressure with a cotton ball...hold it there for a while and try rubbing it in (massaging)

 

[Mr.X]

Wow, 2cc's in the delt? I don't usually push 2cc's in my ass. Is there anyone else that's pushing that much into a delt? And for the original poster, sorry bro, can't help ya. Don't know how much your pushin, but I'd say lower it if it's over 1cc.

Monopoly

2cc's is not that much, I've done 4+ in the delt as an advanced user - would not recommend anyone go that high of course.

 

[Mr.X]

Hey Bros I have been doing ED Tren Shots anyhow the only places I can take are in my Shoulders and Glute anywhere else I get extremely sore. Anyhow my shoulders are very lean and tight every time I shoot the delts usually the middle head everything goes smooth but when I take out the needle some oil comes out actually maybe 1/4 of a CC or more. This is pissing me off because I dont want to waste my gear lol. Any one can give me an idea to avoid this. Thanx for your response!!

I don't think you're losing 1/4th of your oils. When oil/water/liquids run, they cover a lot of surface area, creating the illusion that it's a lot of product. Take 1/4 cup of water, spill it on a wood table and it looks like you spilled 1/4 of a gallon.

what guage pins are you using?

 

[Dieselgoku23]

I'm only using 1cc, I'm using a 21 gauge 1.5 but ofcourse I dont stick the whole 1.5 inches in there only about half or less. I'm going to consider into account and leave the needle there for about 30 to 40 seconds. And wow 4 cc's in th e delts you must have some huge delts! to handle that.