3/4" needle ok for Quad shots?

[JoNeS]

Normally use 3/4" on shoulders, but i fucked up my last delt shot.. so don't wanna do anymore. Will a 3/4" needle be long enough for a quad shot? tx

 

[Mini Viper]

1 inch needles are preferred for quad shots, some even use 1 1/2 inch needles.

I only do quad shots and I use 1 inch needles, its fine.

 

[JoNeS]

but all I have left are 3/4" and wanna know if it be alright to scrap by on quads with them? Or should I just try and get some more bigger ones

 

[Mini Viper]

well, 3/4" needle you might get away with providing you have lean musclely quads then it should be ok. just make sure your needle is all the way in upon injection.
Personally, I would get bigger ones, they're cheap anyway but otherwise give it a go and make sure you inject in the biggest part of your quads.

let me know how it goes.

 

[satchboogie]

if you're lean it should be just fine.

 

[Dial_tone]

Being a lazy bastard, I use 1.5" for everything and just adjust how far in I go.

 

[JuicePimp]

I have successfully used 1" and 1.5" in the quads. Ulter uses .5 slin pins for the quads for tren, so I imagine that 3/4" will work just fine.

I would make sure to bury it all the way in though.

 

[getbigintx]

i ran out of 1.5 needles and have done two shots each quad with 3/4 inch pins and been just fine.. I do make shure I go as deep as I can with the pin and I am pretty lean so I don't think you'll have any trouble asl long as you are careful

 

[Mike P.T.]

I've done them with 5/8 inch needles many times. If you have fat legs then it's not a good idea.

 

[DaddyX]

I've done them with 5/8 inch needles many times. If you have fat legs then it's not a good idea.

yup yup 5/8 inch for me with no problems and my legs arent that small, just lean