How to safely heat up an Ampule?

[ironclaw]

I want to heat up the oil in my Amp this time before injection. I tried running the syringe under hot water and that didnt work to well last time. Can I just boil some water, then drop the Amp in there and let it sit for 5-10 minutes?

Thanks,

why didn't it work well for you? did you run it under hot, hot water and how long? I run mine under hot water in the bathroom after I've pulled it up in the syringe, usually for at least 1 1/2 minutes and that works fine, How hot do you want it?

 

[kmseal3]

I do my injects in the AM so i just fill a coffee cup w/ hot tap water about half the ht. of the vial, set the vial in the cup , brush my teeth then take the vial out clean it up, mix it up , pull what i need then pin. Smooth as silk everytime! TREN is the best!!!!!!!!!!!!!!!!!!!!!!!

 

[cuthroat]

Just warm it under hot water or warm it up in your hands for a while. Shouldn't have any problems injecting it when its cold it just draws up into the syringe alot slower.

 

[richscd2]

load up the juice and stick a blow dryer to the barrel. will heat up in seconds

 

[solidspine]

Amps are hard, don’t put them in a micro wave, 7 seconds and you have a bomb.


There is no way to aspirate, and you need to bake and near boil temp for 30 minutes,

So it is a tough one if you boil the could crack,