Removing BA from "solution"

[PolfaJelfa]

Bump#2

 

[shamrock11]

BA has a low evaporation point. You can hesat it up at loe temos and the BA will evap off. You shouldn't have any problems since the test will have a much higher boiling point.

 

[PolfaJelfa]

Thanks, i believe this is also this way. However it would be nice to hear from someone who has already done this procedure

 

[shamrock11]

Well, I have a degree in chemistry and I know a lot about this even though I haven't been around steriods that long that same chemical rules apply. This is how you could do it. Stick an 18 or bigger gague needle in the vial to vent it and heat some water on the stove until it lightly boils and then stick in the vial. The test will heat up and the BA will evaporate. I believe the boiling point of test will be close to 200 degrees maybe higher and the BA is probably in the 80 to 90 degree range.

 

[PolfaJelfa]

Thanks bro, i feel more confident about this now. Karma to you as soon as i can spread some more.

 

[rjl296]

bp of BA =
205

 

[PolfaJelfa]

that does no tseem right..alcohol sin general ...have low BP and evaportion ratios.....im not a chem wiz but i know that much...where are you tkaing this 205 # from?

 

[Tux]

He's right bro, google it. BA has a bp of 205 celcius. Seems weird to me too but that's the only answer I could find. That's probably why I've never had success evaporating BA... b/c you can't do it, you'd have to set your oven to a little over 400 degrees, and the rubber stopper might melt at that temp. If the BA is too high, not much you can do but cut it.

 

[cobra1414]

draw your solution, add 1 ml of bacteriostatic water, swirl it around and eject the bacteriostatic water.

Your solution now has less BA.

 

[Güclü_oglan]

i'm sorry to tell you but BA boils at around 240 degrees celsius bro (depends a little bit but around 240). I think that dilluting it would be the only easy way around (if you know the concentration of BA in it at present and got more ingredients)

good luck