I tried a new injection method last night

[SCOTTY-TWO-HOTTY]

I've read about doing it this way from some EF Bros. Last night I went ahead and tried it...

I've been doing twice/week 3.5cc injects of Sustenon/EQ/Propionate for the past month. I was planning on sticking to glutes for this part of the cycle, but my glutes were feeling quite traumatized... so I started to use bis/tris/delts. That went alright, until last week when I ended up with a HUGE bruise on my right bicep. I had trouble explaining it to my GF, I'm an awful liar. The Sus/Prop oil is SO thick, even when I use a 23 gauge tip... it seems to take forever to push it into the muscle. I figured it'd be near impossible to get that thick oil through anything smaller. Anyways, last night I was due for a shot and I was dreading having to explain further bruising to my GF... I NEEDED TO DO SITE INJECTIONS WITH A 25GA PIN, so I thought I'd try something new: All I did was load the rig up, put it into a(small)zip-loc bag, and immerse it is a glass of hot water for a few minutes. The oil had the consistency of water after that and went through a 25ga pin like BUTTA! The 25ga site injects went w/o incident... VERY comfortable and no bruising.

Peace,
S.

 

[OAKBOX]

How long have you been juicing? I figured that out after my 4th shot...

 

[HighIntensity]

good you found out but warming gear to make it run smooth is old news

 

[SCOTTY-TWO-HOTTY]

I guess I should have specified "new" injection method, meant new for me.

I've done several cycles in the past, all were much more conservative than this one though: Sustenon only cycles consisting of 250-500mg/week. I've never had a problem(until now) using 23ga pins.

 

[biggerdave]

good for you bro ignore the others. i'll be site inj fina and prop next cycle so i'll be trying that idea out.

dave.

 

[SCOTTY-TWO-HOTTY]

Thanks for the love Dave- Karma for ya

 

[Northstar]

I place my amps/vials on top of the cooling vents of my computer monitor for a few minutes while checking emails, etc... Warms them up perfectly for smaller gauge pins.

 

[biggerdave]

Thanks for the love Dave- Karma for ya

back at ya bro.

dave.

 

[ryker77]

Space heater.
Blow dryier
Clean wash cloth with water in the microwave

But the best method is to remove the pin and place the syrigne wrapper over the end of the syringe and place in up upright. Put in the microwave for about 30 seconds for 2ml.

 

[slipknotbeast]

I'd use a 25 g pin if I was scared of needles too. I use 21 g 1 1/2 inchers for site injections or else it's just not good enough. Be a man!!