Gear getting cloudy when mixing...

[Barch]

Anyone ever have this problem? I've been mixing a few different compounds together in the same syringe, but when I add one certain compound it starts to get kind of cloudy. Is it crashing? Should I just inject separately? Any advice? I don't see any crystals, just some clouding...

 

[ChangNam]

bro it is ok tomix things in the same syring. Do u mean that u kan see them not go 100% together ? Sorry my english is not so good. Hope u understand what i say. Lets say u mix test with deca or primo for x. And because them have difrent base or color. Kan u see that the test not mix 100% together. This is just because of difretn base or color on the compounds. Nothing to wory about at all.

 

[goin on 4T]

That is the oils not really mixing that makes them look cloudy. Oils will look clear when heat is applied, use blow dryer to see. There is nothing wrong and if it crashed and then you injected you would have significant pain and swelling in the area. So you are good to go.

 

[Barch]

That is the oils not really mixing that makes them look cloudy. Oils will look clear when heat is applied, use blow dryer to see. There is nothing wrong and if it crashed and then you injected you would have significant pain and swelling in the area. So you are good to go.

This is what concerns me. I'm having some pretty serious discomfort. It's only been a couple of days since my first injection, so I'm not sure if the gear just a hell of a lot of kick to it, or if it's because it crashed and I injected. I guess I'll find out soon enough...

If it did crash, would an infection ensue?

 

[zedhed]

Bro do you heat it up before you pull it into the syringe? That will help significantly with the discomfort. I dont know about an infection (shooting crashed gear) but I would assume that it would hurt like hell bro and prolly abcess. Heat that shit up before you shoot it, worth the effort.

 

[ALIN]

Anyone ever have this problem? I've been mixing a few different compounds together in the same syringe, but when I add one certain compound it starts to get kind of cloudy. Is it crashing? Should I just inject separately? Any advice? I don't see any crystals, just some clouding...

Its probably just different carrier oils blending together. Give the pin a few shakes...should be fine.

 

[hesnobradpitt]

Yep as said above dif oils or viscosity or temps .

Try put them in a small container of hot water half way up the bottles so they are all warm and same temp then pull them into pin , i have seen this problem and it goes clear with heat in my cases .

Plus less pain when the gear is warm .



Brad.

 

[Barch]

Thanks for the advice, guys... I'll try heating it up!

 

[burnthiscorpse]

I had some tren that got cloudy. Slightly crystalized. It fucking hurt when I shot it. Fucked up my injection site rotation. Was painless before it crystalized. I posted a thread about it a long time ago and I remember getting the advice that even though it crashed a little that it would still be ok to use. I didnt keep using it though. Fucking hurt too much.

 

[ArmaniAK47]

Crashed gear will not cause infection unless it was tainted to begin with.

If you don't see any crystals I doubt it crashed.. Mine have looked cloudy before from mixing different oils, no problems out of the ordinary.