Test prop powder like jelly when dissolved

[hyper24]

Almost all of the test prop powder dissolves, but theres bits left over that look like little bits of jelly floating around. Of course these gets filtered out but what is it, am i losing test because I cant dissolve it all properly?

5% BA 15% BB concentration being used.

 

[goin on 4T]

5%BA is too much. What other oil are you using? GS?
What temp are you taking it to before you add the final oils? How long are you keeping it at that temp?
Prop has a high melting point.
Yes you are loosing the test when filtering it if it does not liquify fully!

 

[hyper24]

Why is 5% BA too much?
What is the point of heating it up to dissolve the prop, when it will cool down it will come out of solution. Solubility of material in a liquid is a function of temperature. It will just crash out when it cools down if you had to heat it up to dissolve. Im using cotton seed oil.

Sorry for the questions, just trying to understand why as my knowledge in this area is limited.

 

[nydj66]

Why is 5% BA too much?
What is the point of heating it up to dissolve the prop, when it will cool down it will come out of solution. Solubility of material in a liquid is a function of temperature. It will just crash out when it cools down if you had to heat it up to dissolve. Im using cotton seed oil.

Sorry for the questions, just trying to understand why as my knowledge in this area is limited.

3% BA is enough to ensure sterility but some bros like to use 5% but it increases the pain level of the injection.

Heating the solution greatly speeds up the process and ensures that the powder dissolves completely. It also lowers the viscosity for when you filter.

I put my beaker in a 200 degree F oven for 10 minutes or so until everything is dissolved.