Please Scroll Down to See Forums Below
napsgear
genezapharmateuticals
domestic-supply
puritysourcelabs
UGL OZ
UGFREAK
napsgeargenezapharmateuticals domestic-supplypuritysourcelabsUGL OZUGFREAK

increase strength on cutting cycle???

leviatan

New member
hi bros,
my question for today :)

can i expect to gain strenght while i will be doing the following cycle:

week 1-9 ganabol 300mg/w
week 1-5 fina 75mg /eod needle in butt, not transdermally or crap like that
week 6-10 testo prop. 100mg/eod

(please dont tell me to run the ganabol higher or longer - i do not have more but i could increase fina or test)

for sure i will be using e/c/a 2 weeks, then n/y/c for the next 2 and so on.
i am about 94 kg, 8-9 % BF at the moment, so if i stick to about 2500 calories a day with high protein, high fat, low carb and carb ups every other weekend - do you think i will be able to further increase my strenght on this cycle or isnt that possible with restrictede calories?

thanks a lot
 
may want to use bromocriptine or winny with fina.

anavar will increase strenght without gaining mass.

fina is great for strength as well as prop

good luck
 
You will still gain strength. It may not be as outrageous as if your calorie was a clean intake of 4000, but you should still but on some strength and even a little muscle.
 
You can easily gain strength while cutting if on AS, especially ones that target the CNS like Fina or Oxandrolone. I am currently starting my 6th week of a Fina cutting cycle. I have been in a caloric deficit the entire time save my free day once per week, and I have put an easy 30 pounds on my bench so far and it doesn't seem like my strength shows any signs of stopping yet. I just started some anavar today so that I can continue cutting when the Fina stops so I'm sure my strength will continue to shoot up.
 
you definately have to use a strong androgen, because without it there is is just no way to cut up and gain strength. at least no way that I know of, If you do know of one please let me know, as this is the problem I always encounter when trying to cut up with AAS. which is usually what I do.
 
Top Bottom