i just finished my breastdrol and dieselbolan cycle. im now in week two of pct
here what it looked like
beast/dbolan 2 caps ed for six weeks
i ran clen 2 on 2 off peaking at 100. i stoped about a week into the second run of clen because i couldnt take the sides
i ran t3 for 6 weeks working my way up to 100mcg. i ran that dose for most of the cycle
and of course liver support, taurine and multi's
after a surgery in may i put on some weight..between that and strength training over the summer..my weight went from 178 to 195. I started the cycle at 195 at the end of august/start of sept. My weight dipped a few pounds at the start but never any lower than 190. It gradually carried back up to 195 and I was able to maintain that throughout the rest of the cycle. As I started to taper off of the t3 in week 5, my weight worked its was up to 200 and now im sitting at 202, and im in pct currently. During the cycle, I was able to shed fat while actually adding size. The strength gains were, and still are unreal….im still making gains while in pct!
I have never been into strength training….Ive always trained for endurance and stamina…low weight and high reps….kettlebells,. for the most part, was my weapon of choice. For the first time ever, I began to dead lift in august. On aug 1st, before the start of my cycle, I dead lifted 200lbs for 4 reps. On October 15th (while in pct), I did 335lbs for 1 rep. Instead of a clean and jerk, I do a clean and then into a push press. aug. 3rd, 115 for 4 reps…oct.19th 165 for one rep. the week before I couldn’t get this weight…I could barely clean it.
Strength, size, and fat loss…im very happy with my results.
For my next cycle im either going to do katanadrol with epistrong or beastdrol
here what it looked like
beast/dbolan 2 caps ed for six weeks
i ran clen 2 on 2 off peaking at 100. i stoped about a week into the second run of clen because i couldnt take the sides
i ran t3 for 6 weeks working my way up to 100mcg. i ran that dose for most of the cycle
and of course liver support, taurine and multi's
after a surgery in may i put on some weight..between that and strength training over the summer..my weight went from 178 to 195. I started the cycle at 195 at the end of august/start of sept. My weight dipped a few pounds at the start but never any lower than 190. It gradually carried back up to 195 and I was able to maintain that throughout the rest of the cycle. As I started to taper off of the t3 in week 5, my weight worked its was up to 200 and now im sitting at 202, and im in pct currently. During the cycle, I was able to shed fat while actually adding size. The strength gains were, and still are unreal….im still making gains while in pct!
I have never been into strength training….Ive always trained for endurance and stamina…low weight and high reps….kettlebells,. for the most part, was my weapon of choice. For the first time ever, I began to dead lift in august. On aug 1st, before the start of my cycle, I dead lifted 200lbs for 4 reps. On October 15th (while in pct), I did 335lbs for 1 rep. Instead of a clean and jerk, I do a clean and then into a push press. aug. 3rd, 115 for 4 reps…oct.19th 165 for one rep. the week before I couldn’t get this weight…I could barely clean it.
Strength, size, and fat loss…im very happy with my results.
For my next cycle im either going to do katanadrol with epistrong or beastdrol