Baking Test Susp ???

[silent says]

What I have is a little bit clumpy.Is it possible to bake to dissolve better?(already tried shaking and warming)It would probably evaporate some of the water dont you think? It is 100 mgs test suspension.Any ideas are appreciated.I have baked my prop before and it actually helped with the pain.225 temp for 20 minutes.
Thanks Silent

 

[RADAR]

What I have is a little bit clumpy.Is it possible to bake to dissolve better?(already tried shaking and warming)It would probably evaporate some of the water dont you think? It is 100 mgs test suspension.Any ideas are appreciated.I have baked my prop before and it actually helped with the pain.225 temp for 20 minutes.
Thanks Silent

Thats the bad thing about SUS. halfway through an inject the pin gets clogged up, no don't bake it, the water will evaporate,and it will be worst than before your best bet is to heat it with a hair dryer before injecting, be sure after loading to shake the syringe to mix it good.

RADAR

 

[silent says]

Thanks Radar,glad you got your avi back.Iv'e heard you can add b12 with it to maybe thin out a bit, is this so?

 

[needtogetarmy]

I heat water in the microwave (or on the stove) and then I place the vial in the water for about 10 mins until it heats up. Shake it and then you should be fine.

As for the B-12, it is water based and mixing two water based solutions is perfectly fine.

Never mix a water based and oil based solution.

 

[silent says]

Thanks for your reply AV.
Silent

 

[scout69]

I USUALLY HEAT UP SOME WATER OVER THE STOVE NOT TO A BOIL BUT HOT I STICK THE BOTTLE IN FOR A FEW SECONDS AFTER I TAKE IT OUT AND INJECT NO PAIN ESPECIALLY WITH wINNY