problems gettin test out of bottle

[FASTECLIPSE]

is there a easier way to get test out of bottle with syringe. it took me for ever.. i blew one cc of air in the bottle to pressurize it.. it is just so thick.. when i finally got it out i had a lot of bubbles.. i tried pushing then back out into the bottle, and it kept blowing the plunger back out.. finally got it though.. is there a easier way or just something i have to deal with..

 

[roidog420]

You should be using 23 guage needles. Put in 3cc of air next time. Those little teeny tiny test bubbles aren't going to hurt you. If they are a real pain in the ass, just shoot them in. You would need like 3cc's of air to really fuck yourself up, so dont you worry! Test is thick dude. But if you are using at least a 23g needle, it shouldn't be that bad.

 

[pumpin-N-humpin]

RoiDog is right on key

 

[Beezers]

18g DRAWING needles. That's what they're made for.

 

[basskiller]

run the vial under hot water... it will lower the viscosity of the oil

bass

 

[the_Pikey]

All these guys are right, also don't try to pull the oil too quickly, the longer it takes you, the less bubbles you'll get and the more room you'll have.

So let's go back over the steps:

1) Run the vial under hot/warm water for a good minute prior to drawing.

2) Get yourself 18 - 23 g needles for drawing the gear.

3) Take your time drawing, VERY slowly, coming to a complete stoping of drawing at times to give the oil a chance to move.


Have fun, its not difficult.

 

[FASTECLIPSE]

thanks guys i will try that