Problem mixing Jintropin

[NJjuice22]

Everytime I try to inject the bacteriostatic water into the gh vial, the vacumm inside the gh vial is so strong it sucks the water in almost immediately not allowing me to angle it to the side so it doesnt pulverize the gh, I even tried holding the syringe back as I mix them but the water still gets sucked in very fast, how can I eliminate this, it has happened everytime so far. I guess my only option would be to inject some air into the vial to , but im not sure if the air could damage the GH.

 

[IronJunkey]

I think if I got you right...you can put another needle in to even the pressure...like a 18G in additon to the one you put in there.

 

[kbrkbr]

I have the same problem with ankebio. I equalize the vial by injecting a syringe of air before the bac water.

 

[NJjuice22]

I have the same problem with ankebio. I equalize the vial by injecting a syringe of air before the bac water.

how much air do you inject?

 

[genarr3]

You don't really have to inject air. Just push an pin into the rubber and let the vacum "escape".

I know exactly what you're talking about. Freaked me out the first time.

 

[bowling ball nutz]

yeah here too, I stick a pin in with no syringe at first to let it equalize

 

[Quadsweep]

I think if I got you right...you can put another needle in to even the pressure...like a 18G in additon to the one you put in there.

I would not use an 18ga. just put a 23ga and let the vacume out then put the water in.

Quad

 

[JP@Ironology]

I have the same problem with ankebio. I equalize the vial by injecting a syringe of air before the bac water.

On ankebio again I see.

 

[NJjuice22]

thanks for the replies, I will use a 23g pin before I mix to equalize the pressure inside.

 

[kbrkbr]

On ankebio again I see.

Leave me alone. You're just jealous.

 

[JP@Ironology]

Leave me alone. You're just jealous.

Good luck with it my friend.