need help with fina

[justwannagetsum]

I just made some Fina as well. It is real cloudy. 2days ago, After I injected it (1/2cc), I got a raise on my quad (slight). It has gone down , feels a bit sore, not too bad though. But It may be that I used an 18Ga needle. It was all I had, So I said fuck it. Any input here?
JWGS

 

[pollock]

run it back through the filter again it should help. Get smaller pins.

 

[nautica]

18 guage - Damn, you are a stud. With fina you could use a 29 gauge. Why bother with the extra pain and scar tissue. It is time to go to the local pham and pick up some pins.

nautica

 

[nikolai_bolkov]

LOL - I just look at that 18g after drawing and I'm damn happy to switch over to a 23g. 18g's a pipe!

 

[justwannagetsum]

18 guage - Damn, you are a stud. With fina you could use a 29 gauge. Why bother with the extra pain and scar tissue. It is time to go to the local pham and pick up some pins.

Thanks LOL My boys had to watch, they said it hurt them to watch more then it hurt me! But I switched the pin to a 25 ga and could not get it out . maybe I fucked it up. can I save the solution somehow?
Thanks!
JWGS