R
roidog420
Guest
Some of you may have heard of this method before, or read about it from me on SEVERAL posts about T400 lately, but I'll post it again anyway since I tried it yesterday & today I have ZERO pain. Before I DO though, I will say that I have tried baking, hot water running, & mixing it with Deca/Eq before I did this, so y'all dont think Im trying to be Mr. Wizard or anything. This was my last straw basically, before I threw the shit into a friggin' dumpster(properly wrapped in aluminum foil & tape to prevent accidental findage of course
). So here it is AGAIN:
1. Take the amount of ml of T400 you are gonna use & suck it into your pin.
2. Take 1/2 that amount of Purified H20, and add it to the T400 dose.
3. Shake vigorously. The shit will mix together & you will have to let it sit for a day or so until it can completely separate.
4. Once separated, work the H20 layer to the top of the syringe & squirt that layer into the sink. In case you get a layer of H2O that is trapped in between two oil layers(which happened to me btw), then you will need to take another pin out & stick it into the solution & suck out the H20 layer.
*The Benzyl Alcohol will dissolve into the H20 layer & will be dipersed as mentioned above.
Thats it

1. Take the amount of ml of T400 you are gonna use & suck it into your pin.
2. Take 1/2 that amount of Purified H20, and add it to the T400 dose.
3. Shake vigorously. The shit will mix together & you will have to let it sit for a day or so until it can completely separate.
4. Once separated, work the H20 layer to the top of the syringe & squirt that layer into the sink. In case you get a layer of H2O that is trapped in between two oil layers(which happened to me btw), then you will need to take another pin out & stick it into the solution & suck out the H20 layer.
*The Benzyl Alcohol will dissolve into the H20 layer & will be dipersed as mentioned above.
Thats it