Please Scroll Down to See Forums Below
napsgear
genezapharmateuticals
domestic-supply
puritysourcelabs
UGL OZ
UGFREAK
napsgeargenezapharmateuticals domestic-supplypuritysourcelabsUGL OZUGFREAK

Heating up an amp?

Sometimes It isn't about pain,some UG gear is just too thick,instead of waiting a whole minute to draw, it can be done in 15 secs if the gear is heated,besides it make for a smoother inj also.



RADAR
 
Draw with an 18g, switch to 23g, heat with hair dryer … Needles are cheap, the one problem with amps other than being a pain to open, if you even think you hit the bottom of the glass with the needle you will fish hook the tip.
 
Draw with an 18g, switch to 23g, heat with hair dryer … Needles are cheap, the one problem with amps other than being a pain to open, if you even think you hit the bottom of the glass with the needle you will fish hook the tip.

I use a seperate pin to draw
 
Bro definately extend that Primo cycle out to 18wks, the real magic starts to happen at 8wks with the Primo, at least for me. I didn't want to stop the Primo at 18wks, I liked it so much, but I already had another cycle bought and paid for, for next time so no more cash for Primo lol.

Eat lots of clean protien and keep us posted on this cycle, do a log bro.
 
Bro definately extend that Primo cycle out to 18wks, the real magic starts to happen at 8wks with the Primo, at least for me. I didn't want to stop the Primo at 18wks, I liked it so much, but I already had another cycle bought and paid for, for next time so no more cash for Primo lol.

Eat lots of clean protien and keep us posted on this cycle, do a log bro.

This is legit schering primo what did you run?
 
boil some water,,,let it cool a bit,,,submerge vial,,,let it soak a few minutes,,,should pass thru pin easily.
 
Top Bottom