Crystillazation of Gear

[motiondo]

I purchased 8 x 10 ML of Test-e... one bottle crystilized...
is it still good...?
I nhad to run warm water over the vial to get it to liquify so i could draw it up...
ANY IDEAS?

 

[Joel1980]

Heat it up and it'll fine.

 

[zedhed]

yeah bro its still good. Just be sure and heat it up to all liquid before you use it each time. Look closely to be sure its all liquid and will be fine.

 

[EonWheels]

It's normal for homebrew's to occasionally crystalize. Just take a pot fill it to about half the size of your gear bottle put a pin in it to release the vacuum and heat until it's clear. make sure you leave the pin in until it's at least almost room temperature before removing it.

Since it's only a 10ml bottle I wouldn't put any other effort into it. If you have say a 50 ml bottle adding a few more ml's BA after it is clear and while its reducing back to room temperature lessons the need to do this...

Just my 2 CC's

E

 

[UA_Iron]

How do you fuck up test e? All it takes is 2%BA to hold it into solution. Doesn't even require BB.

I'd question the numbskull making the gear... But hey, at the very least it sounds like you know there's at least a little bit of hormone in there.

 

[mookymonkey]

probably got very cold somewhere in shipping. had 2 of ten bottles of tren do the same a couple of months ago. just heated them and swirled it around. gtg after that...