Please Scroll Down to See Forums Below
S
shawnerk
Guest
Tried searching....sorry, but- most draw with smaller and shoot with 23. Can I draw with 23 (test ent.) and shoot with 25? Will it just take a little longer? Thanks!
androjunkie
New member
It will take too long, just stick with a 23.shawnerk said:
cdownie927
New member
I draw with 23 and shoot with 23, why would you use 25, stick with 23 takes a little longer but no big deal.
S
shawnerk
Guest
Thanks! K to both! 23 and 23.
LVTitan
New member
these guys have it a little wrong shawn.. a 25 takes longer than a 23. if you can draw it with a 23, then do that, and YES use the 25 to shoot it. i use a 21 or 22 to draw because it just takes way too fucking long to draw w/a 23. take ur time and use the 25to stick, it's slow, but oh so painless.
U
Ulcasterdropout
Guest
I've drawn with a 29, shot with a 25...
Yes, it takes a while
. Like 20 minutes.
I ran low on pinz...
Yes, it takes a while
. Like 20 minutes.I ran low on pinz...
marshallmadman
New member
I draw with a 22, shoot with a 23 to the glutes, and I use 25's for the thighs.
U
Ulcasterdropout
Guest
Nah. I took breaks...Each CC did take about 20 minutes.yomama1 said:
Just a quick question. The smaller the needle, wouldn't there be a lot more pressure in the stream of oil coming out? Or do you just take a really long time to push it through? I've drawn with an 18gage and injected with an 18 gage on a dare. Personally no difference between the 18 and 22's I usually use.
LVTitan said:
S
shawnerk
Guest
thanks ill prolly try a 23 to draw and 25 to shoot first and see how it goes. maybe next week ill try shooting with the 23. k to all. thanks
S
shawnerk
Guest
well, I have 23 1" ers and 25 1" ers... should I get others? Thanks again all.
turbogreek
Registered User
if i'm drawing from an amp...then i use an 18 to draw (it sucks everything right up). if i'm drawing from a vial/bottle with a rubber stop...i use 22's. the 18 will destroy the rubber seal. i have a bunch of 23's left over from a while ago that i use as back up only if i run out of the 22's. the bottom line is that nobody can tell you what size pin to use. depends on what you're most comfy with.
P
PolfaJelfa
Guest
I personall ysuck with an 18 and shoot with 25s.
18= fast suck up
25= painless shot+ less scar tissue
18= fast suck up
25= painless shot+ less scar tissue
S
shawnerk
Guest
ok, sorry... if I use a 23 to shoot, how long should it take to push the plunger in? What if I shoot with 25.. how long? seconds, minutes? what about drawing it with a 23... how long should that take. If I get some 18's to draw, how many seconds to draw that up? Can u tell I'm about to do my first inj. lol.
P
PolfaJelfa
Guest
DO it nice and slow....if it starts to hurt then stop for a little and continue....
No specific time....probibaly 30 seconds up to 2 minutes
No specific time....probibaly 30 seconds up to 2 minutes
S
shawnerk
Guest
sounds good! Thanks everyone.
P
PolfaJelfa
Guest
I preffer to do it over 30 seconds up to a few minutes...im never sore
I just had my 2nd shot of my first cycle of test cypionate yesterday. All I have are 22g 1 and 1/2" pins, so I use one to draw, switch the pin, and stick with the other. Injecting 2cc's per shot, it doesn't take 'that' long to draw, and I'd have to say about 7-8 seconds to stick, aspirate, and shoot; but that's with someone else giving me a glute shot. Nothing to it, no pain whatsoever.
cydex01
cydex01
S
shawnerk
Guest
thanks cydex- good luck on yours too- k to all
hrlydvdson1
New member
turbogreek is right on, amp 19, vial 22, and i always shoot with a 23,,,,no need for anything smaller.....you will never feel the pin. you may feel the juice tho...depending on how thick the oil is.
