Best way to de-crystalize test cyp????

[Seconds]

I was thinking that I would warm some water on top of the stove, then pour the hot/warm water into a coffee cup with the vial sitting upright on the bottom of the cup. I suppose that I don't want the H20 to be too hot as it might damage the test. Any experience out there?

 

[bw1]

Yes, heat it

 

[DannoMight]

I put a vial on on my wall lamp on top of the bulb for a few minutes. worked fine for me.

 

[wee_man]

I've put the vial in the microwave for 10 seconds in past, Worked for me

 

[Para_Shoot]

I've put the vial in the microwave for 10 seconds in past, Worked for me

Yeah? What happens to the aluminum top?

 

[ironcheif1984]

Yeah? What happens to the aluminum top?

lol. Why not try to heat it in the oven at 200Degrees for 15-20 mins

 

[OMEGA]

Microwave a glass of water,

put bottle in hot water for 2 minutes( do not microwave it lol) , take out and shake for 45 seconds

Repeat till re-constituted

 

[gaw31]

does that technique work for v as well?

 

[wee_man]

Yeah? What happens to the aluminum top?

The aluminum top will not cause any damage to your microwave in 10 seconds. I've done it many times

 

[Big_Joe]

I had this problem with some UG gears that was shipped in winter time. It was twenty below outside. I just boiled some water the held onto the vial with tongs and moved it around in the boiling water. Went right back into solution and I injected it. It would crash again after it cooled but I just boiled it again with no problem. I was actually glad this happened. It was my first purchase from these guys and I didn't know if the gear was good. Well when it crashes like this you can see the crystals of what is supposed to be in there. I used them until they closed down. I loved their gear and it was at a great price.

 

[eddymerckx]

lol. Why not try to heat it in the oven at 200Degrees for 15-20 mins

insert pin in top to vent (w/o the plastic--i know, obvious but never know)