Please Scroll Down to See Forums Below
napsgear
genezapharmateuticals
domestic-supply
puritysourcelabs
UGL OZ
UGFREAK
napsgeargenezapharmateuticals domestic-supplypuritysourcelabsUGL OZUGFREAK

sterile vials

Status
Not open for further replies.

micksnowdog

New member
lookin for help from good bro's on here yet again, i have a heap of vials and some rubber stoppers they are all sealed in plastic but obviously not sterile. to sterilise them you just cook em in the oven right?

and there is no reason why test prop and mast prop cant be combined in the same vials right?
 
If you combine 2 compounds into one vial, you'll never really know how much of each you're getting in any one pin
 
lookin for help from good bro's on here yet again, i have a heap of vials and some rubber stoppers they are all sealed in plastic but obviously not sterile. to sterilise them you just cook em in the oven right?

and there is no reason why test prop and mast prop cant be combined in the same vials right?


No problem with that at all my buddy bud bud buddy. Have I told you lately that I love you? :heart::heart::heart: (No homo)
 
Found this on a old thread,

Sterilization of vials and stoppers:

1. Clean your vials
a. Wash with soap and distilled water, rinsing with distilled water
b. Rinse a second time with an alcohol of your choosing. I prefer to use isopropyl. Acetone is also acceptable
2. Dry and Heat your vials.
a. Place them upside down on a baking sheet that has been properly wiped with an antiseptic.
b. Preheat oven to 350*. Place vials in oven and let set for about 30mins, allow the vials to cool to room temp and then repeat the process.
3. Soak stoppers in a hydrogen peroxide solution for a minimum of 10 mins.

Anyone this this is ok? i know i know the only way to truly sterilize is a autoclave.

Also mick, that temp is Fahrenheit, it would be around 180 Celsius
 
Also put the equal amount in the Vial of each, that way you will know the concentration of the compound!



You're good to go.................:)


RADAR
 
put acetone in vial (about 1/4 full).
plug top with rubber stopper.
shake tha damn thing til it drops.
dump out acetone.
microwave until the remains of the acetone are gone.
 
Status
Not open for further replies.
Top Bottom