First injection today

[Sub-Zero]

you put a hole in your muscle and then injected oil.. so your muscle is pissed lol.

make sure you keep the needle stable and injecting slow can help.

i recommend you hit your delts next. then move to your quads. those are the easiest ones. and then the pec is an easy spot once you get the hang of it.

for real? i think pec is way easier than delts...two hands are better than 1

also, OP - some people buy their syringes with 20 or 21g to make drawing faster, and then change the pin (which you should be doing anyway) to a higher gauge for injection

 

[bigb797977]

I didn't even know you can warm it, I have a 10ml vile at 250mg per c, I know people warm up the snap tops but didn't know about the vile, below is a pic if the stuff, kinda wondering if anyone had heard of it


http://tapatalk.com/mu/ad0da199-5c41-2fc0.jpg

You can run the whole vial under warm water or after you fill the syringe, run the syringe under warm water. Within a minute or so it will be noticably thinner. Just make sure to keep the water out of the needle top. It will compromise the sterility of the needle if you get water on it. Hold it by the needle top and run it under running water or put it in a glass of warm water with the needle top sticking out of the water for a few minutes. Just make sure you still take your time injecting.

 

[Marine86]

How long should it take to inject, whats A good time frame

 

[HAYEZ]

for real? i think pec is way easier than delts...two hands are better than 1

also, OP - some people buy their syringes with 20 or 21g to make drawing faster, and then change the pin (which you should be doing anyway) to a higher gauge for injection

I had a bad pec inject one time with tren, the size of my inner chest swole up like a golf ball..i looked retarded and it hurt so bad i never shit pecs again hahahahahahah

 

[lamatit]

How long should it take to inject, whats A good time frame

Are you talking like time to push the oil in?
Takes me less than 10 sec I would say, a lot of people say like 30-40 sec.
I'm not sure what the optimal time really is

 

[Marine86]

Yeah pushing the oil in, it's talking me almost a minute to get it all in

 

[lamatit]

I guess it just depends on how much and what guage needle, 1ml of Test E takes me about 10-15 seconds with a 23g needle

 

[Marine86]

Yeah I'm using a 28 gauge cuz that's all I could find

 

[lamatit]

If i were you i would get 3ml syringes with 1" needle for getting the oil out of the vial, then replace the needle with a 1.5" for injecting