This is what my Jintropin GH did when I mixed..

[Big BX]

it with 1/2cc of bac water from GPZ. It wasn't clear, it was kind of cloudy. But a dirty cloudy. Then I mixed one up using the same water but I used a whole cc and it was clear. They are 10 iu vials so I was looking to cut down on injection volume by using a 1/2cc. Has this happened to anyone else before?

There is a little white residue at the bottom of the vials upon reconsitution. Foam like.

 

[Juice Authority]

That doesn't sound right to me. There should be no white residue at the bottom of the vials after recnstitution regardless of how much BAC water you mix with it.

 

[gilly6993]

Not good....

 

[Big BX]

Not good....

LOL. I was thinking that when I mixed it. Been using Serno's and just switched over to these. Heard they were good.

 

[Big BX]

When they are mixed it is like there is a little " tornado" of white residue coming up from the bottom. Not very high but you can see it. This happened to both vials.

I mixed these vials last night so they have had 24 hours to sit and they still look the same.

 

[xsnrg]

What company made them?

 

[Big BX]

What company made them?

GenSci out of China.

 

[Big BX]

My friend mixed his up last night and then let it sit for a while. He said that it was not clear.

Anyway I hit the stuff last night and the shot was fine. No swelling or irritation at the site. Gonna try it for a while and see if I can tell a difference.

 

[Zyglamail]

You can only dissolve so much solid into so much liquide, I beleive that you should be using a whole cc and not half, that could be why you have residue, cause 1/2cc isnt enough to suspend it all.

When injection BAW into the vial make sure you insert pin in at an angle and inject BAW against side of vial and NOT directly onto gh. GH is very delicate and a cloudy solution is indication of damaged GH. Little "chunks" of undisolved powder isnt uncomming, just GENTLY swirl vial for a bit and it will dissolve, DO NOT SHAKE or it can result in damaged GH.

 

[Big BX]

Thanks Zyglamail, I did run the water down the side of the vial.

Could the GH be damaged by some other means?

 

[xsnrg]

maybe the 1/2 cc isnt enough to desolve 10iu.I was thinking of useing atleast 5 cc of BAW so that i could do 2iu at a time.

 

[red505]

I follow Zyg's method and always have gotten a clear mixture, never couldy, but usually with a slight froth on top, looks like bubbles which disappear after a few minutes.

 

[DrJMW]

Another trick:

Before adding the BAW, use the syringe to suck the air out of the GH vial. Then add 1ml per 4IU along the side of the vial. Swirl gently, never shake or agitate for Zyg is correct--rHGH is very delicate. It should be clear when injecting.

 

[Big BX]

I follow Zyg's method and always have gotten a clear mixture, never couldy, but usually with a slight froth on top, looks like bubbles which disappear after a few minutes.

I know how to mix GH. I have been using Serno's and Humatrope for over 8 months now. I will mix again tonight and will let you guys know how it goes.