opening and filling from amps

[reivog]

Hello gang

What is the best way to open a Sust250 amp ?

Do any of you file around the top 1st? or can this generate small glass fragments which you dont want to be injecting ?

or do you just break the top off with your thumb?

also fillng the srynge...

i take it you just stick the pin into the amp once its open and slowly draw out all the fluid ?

cheers gang..

oh, 1 more thing

How long does it take for DBol (thai) to kick in roughly?

i started my cycle today, and since 7am this morning i have taken in 20mg of Dbol (4 x 5ml tabs) and dont even fell anything at the moment, not even as much as a muscle twitch or anything?

thanks in advance

paul

 

[alien amp pharm]

Well most amps (esp. quality ones) have some sort of marking at the 'neck' of the amp. My test enanthate amps I'm currently using has a small dot one the neck. Simply hold the amp base with you fingers then press the top part of the amp against a hard, flat surface AT THE DOT OR MARKING. This is what it's there for. Guaranteed clean break every time.

Dbol depends on individual and brand. For me I didn't get much out of mine, but I noticed the most around week 3.

 

[decadur]

alien amp pharm,
...love the handle.....
And the avatar.......

 

[drveejay11]

BUMP....you can't injectbroken glass fragmentS...CAN YOU??? I would have assumed they were too big to pass through needle?!

Also, I usually just open the top/plunger side of the syringe and dump the vial (once opened) into the syringe then replace the plunger back in. It's a lot easier than pulling up the fluid from the broken (pressure-less) vial.

Is this okay????

 

[littleRock]

How long does it take for DBol (thai) to kick in roughly?

i started my cycle today, and since 7am this morning i have taken in 20mg of Dbol (4 x 5ml tabs) and dont even fell anything at the moment, not even as much as a muscle twitch or anything?

dbol should kick in about 20min after you take it. You'll feel warm and possibly a little flushed. After 35min you'll want to remeasure yourself as your arms should be about 1.5" bigger!

Just kidding about the last part. None of this stuff is going to make your "muscles twitch".

 

[drveejay11]

BUMP....you can't injectbroken glass fragmentS...CAN YOU??? I would have assumed they were too big to pass through needle?!

Also, I usually just open the top/plunger side of the syringe and dump the vial (once opened) into the syringe then replace the plunger back in. It's a lot easier than pulling up the fluid from the broken (pressure-less) vial.

Is this okay????

Bump.answers anyone?

 

[ROLGOR]

Do NOT file it. You will get glass powder inside which you could inject. You also have a chance of causing the whole amp to break.

 

[alien amp pharm]

BUMP....you can't injectbroken glass fragmentS...CAN YOU??? I would have assumed they were too big to pass through needle?!

try using an 18 gauge. -I bet you could just about suck the whole amp thru that!


Also, I usually just open the top/plunger side of the syringe and dump the vial (once opened) into the syringe then replace the plunger back in. It's a lot easier than pulling up the fluid from the broken (pressure-less) vial.

Is this okay????

I've never heard of doing this, but I see no reason why you couldn't, as long as it's continuously sterile.
How do you reseal your vial each time though? Plus you can add air to the vial to create pressure, if that's a concern.

DECADUR: Thanks man - I might change the ole avatar here soon, it's too distracting for me being on so much test

 

[alien amp pharm]

Okay, here's the easiest way to draw from an amp:

1: don't waste money and time on an amp opener. Place the amp between your fingers holding the base tightly. Press the upper part of the amp upright on a flat/hard surface with the score (marking on the neck of the amp) facing the surface (=break at the score/mark). Press down gently. -the top comes off cleanly and with little pressure required.

2. Stick the pin in the amp all the way to the bottom (18 ga is preferred.) Draw the gear out very slowly. You will get some air plus some tiny air bubbles during the drawing out. When all the gear is in the syringe, turn the syringe upside down (needle upward). Replace the 18 ga pin with the appropriate 'smaller' pin you're going to inject with. Now push the gear slowly to the top until just gear is beginning to come out. This gets rid of the air.

3. Stick that sucka into your muscle and inject slowly after apirtating.

 

[alien amp pharm]

BUMP....you can't injectbroken glass fragmentS...CAN YOU??? I would have assumed they were too big to pass through needle?!

Also, I usually just open the top/plunger side of the syringe and dump the vial (once opened) into the syringe then replace the plunger back in. It's a lot easier than pulling up the fluid from the broken (pressure-less) vial.

Is this okay????

Okay, maybe I'm confused here.....Are you talking about an amp or a vial??????