Im tryin 27G 1/2 inch what do yall think?

[Your_Moms_Kneepads]

IT'LL WORK

Not even close!
Try pushing suspension thru a 27g needle. It will clog it. Lots of guys plug 25g and lower gauges with suspension. Unless there is a MICRNONIZED test suspension,
On another note- micronized winnie WILL in most cases work with 27g (almost always)

 

[2Thick]

A 1/2" needle is just fine for a delt injection.

 

[Just_Grow]

it will work your gonna be there for a while tho.

 

[Pi Kappa Phi]

I just did it and there were no problems, its not jurox, ive done it before and wont touch that nasty shit! ITs aquavirion and it pulled and injected easily

 

[Hugh Gellatts]

With the shorter pins make sure to keep the injection volume pretty low. You don't want a big lump near the surface.

 

[shredz]

I use a 29 gauge 1/2 in for all my bi, tri, and delt injections I've never had any problems. Test Suspension will probably clog I use Deca and Fina for all mine.

 

[B182]

It will work. Most of these guys here saying it won't either haven't tried it, or used a 3ml syringe. Doesn't matter if the needle is only 5/8'' if you are lean- if you inject slowly it will dissapate through the fibers and won't form a pressurized pocket of oil, none will leak back out. No scar tissue, zero pain. Bill Roberts advocates using 29g pins for everything, and if there's aproblem with suspension clogging you can solve this by using a 23-25g pin, and drawing up the suspension, then forcefully squirting it back into the vial-it will break down the particles so they will work in a smaller pin. Also, if you are using a 1ml insulin syringe, the smaller surface area of the rubber plunger gives a hydraulic mechanical advantage making it much easier to push the solution through a smaller pin than a thicker 3ml syringe.