I need an answer and fast!!!!!!!!!!

[kingpin101]

I just extracted 2ml. from a bottle of t-200,and it came out very slowly and thick,and has a lot of air bubbles,
Is this normal? or should the consistancy be thiner?
Thanx

P.S. its tornel t-200

 

[MUSTANG_18]

I get the same thing when I draw up Sust. Flick the syringe with your finger and they should all come to the top, inject them out till one drop(of juice) runs down the pin and you should be good to go. You could also run it in warm water to thin out the oil so it is easier to draw up. Good Luck!

M18

 

[kingpin101]

Thanx bro for the info.
is the gear always so thick?

 

[MUSTANG_18]

I have not used T-200 but my Sust was always a little think(Niles) the warm water helped though.

M18

 

[STUDLY76]

LET IT SIT FOR A FEW HOURS, THATS WHAT I DO

 

[web_dj]

Bro all those little air bubbles you dont have to worry about it is just the big ones just cap the pin and let it sit for like 5 minutes and then you are good to go

 

[PimpnAintEasy]

I just extracted 2ml. from a bottle of t-200,and it came out very slowly and thick,and has a lot of air bubbles,
Is this normal? or should the consistancy be thiner?
Thanx

P.S. its tornel t-200

Did you keep the bevel completely submerged the whole time? Usually I get a lot of bubbles when I am not careful about this while drawing. Also, you held the needle up and the vial upside down, right? Tornell T200 is not very viscous compared to other oil-based gear in my experience.