Please Scroll Down to See Forums Below
napsgear
genezapharmateuticals
domestic-supply
puritysourcelabs
UGL OZ
UGFREAK
napsgeargenezapharmateuticals domestic-supplypuritysourcelabsUGL OZUGFREAK

HGH measurement

floridalife

New member
Ok this may be dumb but i have read 50 different methods of measure and formulation

And after taking it for 2 days I better make sure to how the heck much I'm taking!!

Genlei Jintropin

10IU Bottles
I mixed 1cc or 1ML (same thing right?) of bacterostatic water into one bottle

so with 1cc of water in a 10iu bottle

i was using a slin/insulin type syringe

and was drawing i/u's out of it based on the markings on the syringe

like 2iu or 3iu etc

Am I doing this right? Because i read iu's on that syringe might not actually correlate to HGH iu's

Please advise thank you!

PS on a side note i read how fragile hgh is and not shake it, well i dropped my vial on the floor, after it was mixed.. chance that i destroyed the effectiveness of it?
 
the little amps of water they sent with it should be about 1cc, so the 10 mark on the 1/2cc syringe should be 1iu, 20=2iu,30=3iu. if not i've been taking it wrong for 2months :)
 
so 1 mark between 0 and 10 units marking on the insulin syringe should be 1 iu right?

==

or is the above comment right the 10 mark is 1/iu? the above comment sounds like he's 10'ius or 20 ius etc lol

i'm confused
 
uhh that doesnt really help much i am using a slin insulin syringe

one side says units on side says 1cc

so if it was actual units then 1 mark between 0 and 10 units would be 1iu?

but when doing the math it looks like 10 units on the slin syringe may be 1i/u is that right?
 
slin pins are marked in .01 of a cc. so if its a 1 cc syringe, it goes up to 100, if half cc it goes up to 50. either way, 10 = 1 iu 20=2 iu 30= 3 iu etc...
 
Top Bottom