help with shooting

[adpeterson33]

my test suspension is very clumpy. I draw it out with a 18' and shoot with a 25'. It takes a while to draw, but whats worse is i can barely get it to shoot into any muscle, so i end up jabbing and teraing up my spot injections. Can i heat up test suspension like i do prop to ease the liquid up??? any suggestions?

 

[GUARDIAN]

when u say clumpy do u just mean thick like molasses or syrup?

 

[boletryne]

to the water base (though, not an issue if using a product suspending in propylene glycol or oil) the testosterone will most likely settle to the bottom of the vial and that shaking the vial is needed in order to insure even dosing. This is true for all water based steroid suspensions.

It should be noted that test suspension is usually a very painful shot, so it is often cut with something else, such as B-12, or other steroids. And yes, you can mix a water based steroid with an oil based steroid in the same syringe. It looks like a lava lamp, and you can use it as a level if you are building something, but no, there´s no problems with injecting a mixture like this.

try baking it before you draw it out... and shake well

 

[searay]

is the suspension water based ? if so whats happening is if the pin is pointing down during injection all the powder is falling to the top of the syringe making it impossible for it to get through the pin. you have to keep the syrings level to the ground so thet water and powder are passing through the pin at the same time. good luck getting it through a 25g unless you dilute it with water or b12. suspension is very tricky to shoot as you need to constantly shake the solution to keep it mixed and you cant do that while you shooting it. if it oil based then i have no idea what to do as ive never delt with oil based suspension.

 

[n1tro]

For the record I shoot my test suspension with a 25g and draw it with a 18g not problems all I do is shake the vial before I draw it up and inject it right away. Are you sure your stuff is legit?

 

[searay]

my test suspension is very clumpy. I draw it out with a 18' and shoot with a 25'. It takes a while to draw, but whats worse is i can barely get it to shoot into any muscle, so i end up jabbing and teraing up my spot injections. Can i heat up test suspension like i do testosterone propionate to ease the liquid up??? any suggestions?

oh, from your first post i thought you were having problems getting the gear tp shoot on the first try. apparently not........
im speaking from past experience, dont have any suspension and wouldnt think of using it unless i was gonna compete in a power meet in a couple of weeks because there is much better test than suspension for regular use.
you still havent said if it is water based or oil based..............

 

[needtogetaas]

Sounds like some fun shit to deal with. Clumps ewwww. Shake the hell out of that stuff.

 

[Cryptlord]

It should be noted that test suspension is usually a very painful shot, so it is often cut with something else, such as B-12, or other steroids. And yes, you can mix a water based steroid with an oil based steroid in the same syringe. It looks like a lava lamp, and you can use it as a level if you are building something, but no, there´s no problems with injecting a mixture like this.

My only disagreement with this statement is the fact that mixing water and oil based steroids can created air bubbles in the solution when you inject and this is a haven for bacteria to grow and greatly increases the risk of an infection.

Just something to think about.

 

[khemix]

Sounds like some fun shit to deal with. Clumps ewwww. Shake the hell out of that stuff.

Lol my thoughts exactly.