heatin gear before shooting

[4545]

Whats the best way should i put it in the microwave for like 7 seconds or just run it under some hot water? Always seems to go in alot easier when heated. I hope this isnt affecting the gear at all. What do you guys do? thanks

 

[Dante666]

I'm not the authority on this at all, but from reading on injections in preparation for my first cycle the best way to do IMO is to run it under hot water. It shouldn't hurt the gear but it does help the injection.

 

[kenpolifter]

Bump that, hot tap water with the cover over the pin.

 

[WelshInjectable]

I just run hot water over the syringe, works well especially with oil based injects.

 

[satchboogie]

bump

 

[TheDarkSideNinja]

BUMP!!!

 

[Johnny Cut]

If u are gonna heat your gear, running it under warm water works well, also u can put some water in a pan and let it sit on the lowest setting on the stove for about 5 mins, u obviously dont want it to get too hot

 

[Mr. Las Vegas]

When I use Mexican stuff I always microwave it for 45 seconds then run it under cold water, I repeat this 3 times and it works great and does not affect the gear. If your not afraid of an infection just run it under hot water.

 

[shoichi]

I run it under hot water for about 20-30 seconds. It's simple.

 

[NZkiwi]

i run it under hot water for about a minute, helps a little with the pain from sust, but doesn't eliminate it.