Please Scroll Down to See Forums Below
Fina Conversion
- Thread starter rudyg
- Start date
Check out basskilleronline.com
blueeyeddevil
New member
I dont think how many mg/cc has anything to do with the BA and BB requirements . I hav never tried to go to 150 , I stick with 100mg/cc and hav never had any problems with it crashing and the caugh is pretty minimum. Everyone has a differant opinion but I dont like the BB and use as little as possiable . I do use 2-3 cc's of the BA per 50cc batch. Bonds nicely and doesnt really sting so much.. I also use Basskiller for my basic recipes
Mac173
New member
Great site. Didn't know to many people knew about him.
blueeyeddevil
New member
I have used basskillers info. for the base of a lot of my progress the last couple of years .. Love his insulin info. and went completely by him when i tried the IGF1 and had really great results.
Mac173
New member
I haven't been on there for a few years, but always remember him having some really good info.
You know it!!
Alot of people assume that if you ask a question that you must not have done your research. This is a bad assumption. The problem with alot of the blogs out there is that people tend to make conclusory statements without any substantiation. Also, alot of the info is contradictory and anecdotal rather than based in scientific fact.
I have looked at basskillers.
The closest formula that I have seen to what I want is as follows:
2mlBA+6mlBB+6gTREN+26ml oil divided into 6000 = 150mg/ml
So would:
3mlBA+7mlBB+8gTREN+35ml oil
yield the results I want? It seems logical to me, but it is always nice to have validation from those more experienced.
thanks
I have looked at basskillers.
The closest formula that I have seen to what I want is as follows:
2mlBA+6mlBB+6gTREN+26ml oil divided into 6000 = 150mg/ml
So would:
3mlBA+7mlBB+8gTREN+35ml oil
yield the results I want? It seems logical to me, but it is always nice to have validation from those more experienced.
thanks
Basskillers knows more then I do... Sorry, just trying to help!
I know. I started my cycle at 1cc ed of 75mg/ml.....week 4 came and I didn't see or feel anything. So, I started injecting 1.5cc ed. Then the last 2 weeks of my 8 week cycle I was doing 2cc ed.
At 2cc ed of 75mg/ml I started to notice results, but only ran that level for two weeks. So I figure that my next cycle should be a higher concentration so I don't have to inject 2cc ed.
I thought at first maybe my fina was junk or that I messed up the conversion. But, I ran low during the cycle and ordered fina from a different supplier. I doubt that both suppliers were bad or that I messed it up twice. So, my guess is that my body doesnt respond well to Tren A and I can handle higher doses. I am 255lbs. Maybe that makes a difference.
At 2cc ed of 75mg/ml I started to notice results, but only ran that level for two weeks. So I figure that my next cycle should be a higher concentration so I don't have to inject 2cc ed.
I thought at first maybe my fina was junk or that I messed up the conversion. But, I ran low during the cycle and ordered fina from a different supplier. I doubt that both suppliers were bad or that I messed it up twice. So, my guess is that my body doesnt respond well to Tren A and I can handle higher doses. I am 255lbs. Maybe that makes a difference.
I know and knew before I started that you're supposed to do test with fina. I have been lifting most of my life but never did aas because it was never available to me. (I didn't look too hard, either). A friend that I recently met is the first person that I know that has admitted use. He told me about finaplix. So, I thought I would give it a whirl. I'm a risk taker by nature. Also, he said that he has done fina only with good results. I could get test p that same way thru synovex, but I still wouldn't have access to any anti-e. - I'm a risk taker, but I'm not gonna risk gyno...that's one side I can't handle.
Similar threads
