Best technique for heating gear...

[danymal04]

Take a shower and as soon as you get out, shoot your gear... goes in smooth and good, i learned from my b-complex, the most painful thing i shoot that its the best to do it then. No aches, no pains, after I shoot, I dont even think about it until its time to shoot again. Warm shower.

 

[motoxer125]

i usually just put in in the microwave on high for about 8-10 minutes. then wait 1 minute untill it cools and inject. after about a week of everyday injects i have muscles popping up i didnt even know about!


...at least i think they're muscles!?!?!

 

[DRG_]

Hotplate.
Very convenient access.

 

[trickster6487]

why dont you just stop bein such a pussy and just take the pain. lol jk

i usually put the vial in between my legs by my nut sack, warms up pretty quick too

 

[fbodyguy02]

I don't know why no one has mentioned just putting the vial in hot water (not boiling) from the sink. I just run some hot water into the sink and let my vial stil in there for 3-5 mins.....works with amps too.

 

[td1111]

I would worry that the extreme heat might destroy the compounds. I simply warm with hot tap water, dilute with sterile oil, and then massage the area afterwards. Minimal pain this way.

 

[SpyWizard]

double boiler..

boil water, rolling boil..

turn off heat, place vial with needle in the bottle, and allow to return to room temp..

good luck.. I will roll the vial about 5 minutes into the process, that is to mix the product well.. (use a oven glove)

goodluck

 

[glennds]

I don't know why no one has mentioned just putting the vial in hot water (not boiling) from the sink. I just run some hot water into the sink and let my vial stil in there for 3-5 mins.....works with amps too.

more effective if you boil the water first fbody. that extra heat can liquefy your gear quickly.

if you want really quick results immerse vial in saucepan of boiling water so the level is below the top of the vial. dont leave in too long, as the heat could crackyour vial.

 

[solidspine]

And you only do this once? Or everyday before you inject

I've heard in another thread this works wonders. What does it do to the gear chemistry to make it painless?

You only need to bake gear once,

It cooks of the extra BA in the gear itself.

 

[Burpees]

double boiler..

boil water, rolling boil..

turn off heat, place vial with needle in the bottle, and allow to return to room temp..

good luck.. I will roll the vial about 5 minutes into the process, that is to mix the product well.. (use a oven glove)

goodluck

Duh! You other guys got some complicated shit going in, must take you hours to inject! Heh.. Even for 'baking'/'sterilizing' you're best off double-boiling.

I just take the smalled pyrex dish I have, put a couple inches of water, heat in the micro till it starts to boil (60-90 secs). I sit my vail in there, when the glass is hot to the touch I swirl it.. while I swirl I usually heat the water again and just leave the vials in there while I alcohol swab my injection site and prep my needle..