Please Scroll Down to See Forums Below
napsgear
genezapharmateuticals
domestic-supply
puritysourcelabs
UGL OZ
UGFREAK
napsgeargenezapharmateuticals domestic-supplypuritysourcelabsUGL OZUGFREAK

5000iu amp HCG - how to split it?

Less margin of error? What?
How hard is it to add 1cc of bac water to power then mix, then remove hcg and transfer to new vile.
Then every inject, fill slin pin to the first 10mark and inject. All your doing is injecting almost a full cc of water. Why? And don't say margin of error cause that makes no sense. Is it because thats the way to were taught? I'm not trying to be a dick bro... don't get me wrong.. Just saying there is no need for a full cc for only 500ius.

I use the same method and inject 1cc for 500iu.

When he says margin of error think of it this way - if you're off "a little bit" with your 1/10 mark on the slin pin, it is far greater a mistake than me being off "a little bit" with my 1cc. You can potentially be injecting double the amount if you're off 1 tick with your 1/10 cc method.

It's just preference, no need to argue. The end justifies the means.

And yes, sometimes HCG with bacto water stings a bit.
 
I use the same method and inject 1cc for 500iu.

When he says margin of error think of it this way - if you're off "a little bit" with your 1/10 mark on the slin pin, it is far greater a mistake than me being off "a little bit" with my 1cc. You can potentially be injecting double the amount if you're off 1 tick with your 1/10 cc method.

It's just preference, no need to argue. The end justifies the means.

And yes, sometimes HCG with bacto water stings a bit.

Oh I was arguing at all. Just wondering.
And swole even if someone did mess up and go to the 2nd 10 mark you are only injecting 1000ius, well under the 2000ius a week range that most people swear by that you shouldn't exceed.
You are right it is all preference, but I was also getting at that there is alot of alcohol in that bac water for a full ml.
 
I use the same method and inject 1cc for 500iu.

When he says margin of error think of it this way - if you're off "a little bit" with your 1/10 mark on the slin pin, it is far greater a mistake than me being off "a little bit" with my 1cc. You can potentially be injecting double the amount if you're off 1 tick with your 1/10 cc method.
It's just preference, no need to argue. The end justifies the means.

And yes, sometimes HCG with bacto water stings a bit.

There ya go. Someone gets it. Didn't think I needed to explain that concept but I guess so.

USMCNUT- It's a matter of persoanl preference. I feel no difference whatsoever regarding pain and irritation from an additional 9/10cc of bac water so that's how I do it. If that's not the case for you then make yours with a higher concentration. That's why I specifically stated in my post "desired concentration".
 
Top Bottom