HELP w/Test Cyp brew

[richardj]

Can anyone provide step by step on cyp conversion.
I have tried several times to make cyp 250g/ml using:

BA, BB. Grapeseed oil

BA & BB are supposed to dissolve powder. It stays milky and grainy. Even with a touch of heat. Afraid to go OVER 212 degrees to ruin effect of mixture.

Please help as I am WASTING much powder.

Thank you!!!

Rich

 

[zedhed]

Use 2/20% for your Ba/Bb.
Combine Ba, Bb and oil.
Put on heat till completely clear.
Then add powder, stir constantly. Add just a teaspoon or 2 at a time.
After you have all the powder added contine to let cook and stir for another several minutes
Let it cool enough to handle and then filter
Dispense into vials and you should be all set.
Good luck and let us know.

 

[richardj]

Zed,

Thanks for the reply. I have been adding the powder to the BA/BB THEN heating. It is great under the heat-all is melted and quite liquid. It is after I remove that it begins to turn into a gel, then finally a white Sludge.

I just don't see what dif it will make as the core material is not remaining liquid before adding the oil.

Rich

 

[zedhed]

IDK the answer bro but I know it works for me. Sorry cant be more scinetific about it for you.
Maybe it has to do with the solvents being mixed better??
Like that thumbnail too.

Cyp is not easy to brew any way you do it. I much prefer Enth. As far as how you feel on either, its identical or dam near.

 

[stiphy]

there is a conversion calculator that you can use just to make sure you have your %s of oil, test, ba, and bb correct. have you checked that?

 

[richardj]

I do not know of this. Please give directions as to where one might find one of these calculators.

Thanks

 

[stiphy]

I tried to post the web address but it wouldnt let me because i dont have 25 posts yet.

PM sent.

 

[Ox-Sandra-Loan]

Of course it is not going to remain a liquid until after you add the oil. The oil also dissolves the test cyp, you can't expect that amount of BA and BB to dissolve all that test cyp on its own. Add the oil! I actually can't really understand why you haven't done that.
like zedhead said "Combine Ba, Bb and oil." heat that, and dissolve the powder.

 

[richardj]

So sorry for misunderstanding. I have indeed combined all liquids. I have added more oil to my mix and reheated. Still coagulates back to solid. GRRR!!

BTW, Oxandrolone, How many mg do you take on daily basis. I am about 220lbs, and have this stuff in powder form.

Rich

 

[Ox-Sandra-Loan]

Ahh sorry, I didn't realize you had tried that...it sounded like you hadn't yet added the oil. In that case, I am not sure why it won't stay in solution, it should if the ratios are correct...are you sure of your calculations? what about the powder itself..how confident are you in the powder?
To be fair, I've never bothered trying to brew up cypionate, since I get enanthate cheaper, and it is easier to work with.
Maybe try making it up at 200mg/mL? it should definitely hold at that strength. Another reason I prefer enanthate...I can easily make it 400mg/mL.
My current cycle is Test Enanthate, EQ, and Deca...all of which I have made from the raw materials. (lots of mgs, but not on a daily basis hehe)
I hope you can get this working for you, would be awfully frustrating to be wasting materials.