Advice on short cutting cycle

[bigman75]

Long cycles tend to get "stale" for me so fir my cutter I'm keeping to 6 weeks. My question (since I don't cut much) is: Would you rather run 6 weeks of prop with t3/clen stacked, or prop/tren ace?

I've never run tren before so I have no experience with it.

I can also use var to replace the t3/clen or tren is it's a better option.

(Just finshed a 12 week run of enanthate, looking for ideas for spring cutter.
5'10" 240# just measured at 18% bf)

 

[EZ_E]

Of those 2 choices option 1....the 2nd one only if you're gonna extend the prop 2 more weeks


~EZ