what am i doing wrong?

[samsaige]

I never had problem extracting prop from the bottle, but i am having a hard tome pullin cyp out.

I thought it was lack of air, and i added air to the bottle, that did not help.

if i put the needle in the bottle top and pull back with syringe, it is a fight to pull the syringe handle down, it feels like someone is pulling it back from inside the bottle, almost like a vacum. when the cup does come out, i drizzles down into the syringe slowly and with a ton of bubbles?

any suggestions

 

[DaveTSI]

it sounds like its just too thick, what gauge are you using and what brand test is it?

 

[knockdown357]

Set your vile in some hot water for about 5 min this will thin out the oil and make the whole process easier. Then inject air into the vile the fill the syringe. Hope this helps.

 

[GUARDIAN]

try a bigger gauge. it is slow for me when i use 23g

 

[b_light]

fuck hot water, use a hair dryer or heating pad to heat it.

 

[rubberneck]

try a bigger gauge. it is slow for me when i use 23g

agree

 

[702daswoll1]

Boil up some water and set the vial in it and heat the mixture up. Problemo solved.

 

[silverskyline]

If all that dosnt work have you tried pulling the syringe back then sticking the vial and just letting it drip in rather than sticking the bottle with the suction forward and attempting to pull back (giving the vaccume effect).

This should work a lot better with a larger gauge

 

[jumpmaster82]

just pull it with a bigger guage then switch it before you pin

 

[advanced-stealth]

Agree^^^^

 

[eddymerckx]

i use 18 gauge to draw--i am on impatient sumbish

 

[samsaige]

ok, i have nothing bigger than 25 g.
that is what i am drawing with.
my next shot is sunday, i will use heat, to loosen the oil up, i will update on the result.

Thanks for all the advice guys.

 

[Mavafanculo]

25 ga no wonder. the prop is very thin so you got away with it. but you should use at least a 23 preferable a 22 to draw the cyp

 

[DaveTSI]

i draw with 22ga. so much faster, than just switch to 25ga.

 

[b_light]

I drew some ug cyp with 25's, took a while but it got in there.

 

[xrsist]

we use 19g to draw cause their free, just gota be careful with the vials