Wasted Some Juice , Im Pissed!!

[V-SHAPE]

IM pretty new to sucking juice from sust amps, and eveytime i put the gear into the needle ,im always below the 1cc mark. Today was at about 3/4 of a cc . =( ....Bros any tips on getting the maximum juice out of an amp????

please i would appreciate a step by step guide from a vet to a rookie, thanx -peace

 

[MUSTANG_18]

Just stick the needle in the amp and draw slowly until all of it is sucked up. If there is any left over then just nmove the pin around and pull the plunger and you should be able to get all of it out. You could also heat up the amp under warm water for 5 min to thin out the oil before you break the amp open

M18

 

[DRQUICKS]

Are you positive the amps were a full 1cc in the first place?

 

[BigBazooka]

Next time remove the plastic cap from the needle before drawing

j/k, just use a big ass needle for drawing..

 

[Maxx Out]

Never had a prob. w/my shit! Always 1cc maybe a bit more!

 

[DMSO Demon]

same here!

 

[uglyass]

I have the same problem bro, I heat the amp up before drawaing, I use a cannon to suck it up and I make sure I always get as much as possible out.

Yet every time I push the plunger up it reads about 0.9ml I think its just cause some of the juice stays in the first needle and some is in the new one.

I read somewhere you can just pour it in to the top of the syringe but the syringes I have the plunger doesnt pull all the way out.

UglyASS