Tren Conversion Question-Let it settle?

[Dr.RobertBanner]

So I've started my first conversion (how exciting!) and after letting the pellets dissolve (took quite a while) I added the oil. I won't be needing the tren for about two weeks, and I've read that instead of pre-filtering w/ the coffee filter, you can just let the binder settle at the bottom and then draw off the relatively clear tren and then use the sterile filter. Has anyone tried this? How long does it take the binder to completely settle?

 

[projection]

I'm nut sure about the settling part, but when I converted mine I pre-filtered and it made the syringe filter part a lot easier. If you do draw out some of the binders it will probably clog your syringe filter half way through.

 

[magdelana]

Hiya doctor, my brother made a tren injectable about 6 weeks ago and he and i both noticed that there was no more settling after just 12 hours or so once the pellets had dissolved.

Yes the steps you mentioned are just what he did. Once it is fully settled draw it all up down to just the detritus at the bottom. Then push it though the syringe filter. You might tilt the vial over a bit so that the tren pools up in the corner. It is easier to draw up the tren without pulling up also the waste produkts. When you tilt it the stuff at the bottom sort of stays in place and just the tren moves over if you tilt it gently.

 

[tee]

Doc,

The longer you let it settle, the better. I usually wait for one full day to get the most I can. If you pre-filter with the coffee filter, you will lose some of it due to the process. If you just draw it off the top with a pin, you will only lose what you cant suck off the top. Dont go into the gunk too far with the pin or you could clog the filter. Since the stuff is so cheap to make, I dont bother trying to get every drop sucked up into it. Just be sure not to disturb the stuff when you pick it up to suck it out. I did that once and messed the damn thing up.Have fun!

 

[Dr.RobertBanner]

Thanks Mag and tee

 

[bigfatty]

At that point where it's all settled and ready to prefilter, I'll heat up some water and put the vial in it for about 5 mins. Then I swirl it around. I don't think it matters but I do it just in case I can get an extra .000001 mg out of it. Then pour it down the coffee filter. That was my second attempt (much better than the 1st I would say.) I cant imagine there being a big difference from not prefiltering and going straight to the syringe filter vs prefilter and syringe filter. Basically, don't think it really matters.