Please Scroll Down to See Forums Below
napsgear
genezapharmateuticals
domestic-supply
puritysourcelabs
UGL OZ
UGFREAK
napsgeargenezapharmateuticals domestic-supplypuritysourcelabsUGL OZUGFREAK

Test solution is clumping up....

trinidad

New member
I bought 2 vials of some UG test a couple of months ago and stored it away. I went to use it and they were both in solid clumps. I ran them under hot water and they disolved for the most part although still cloudy. I went to use it again and same thing. Anyone else have this happen or have any suggestions? It's kept at room temperature.
 
what's the mgs/ml...This is very common with test cyp with the higher concentrations 250-300mgs/ml. I just heat up the vial with a hairdryer on high for a couple of minutes and shake the vial real good. You can still use it.....enjoy :evil:
 
It's 250 mgs. Funny thing is when it came it was clear. Oh well, guess I'll just keep heating it. Thanks
 
trinidad said:
I bought 2 vials of some UG test a couple of months ago and stored it away. I went to use it and they were both in solid clumps. I ran them under hot water and they disolved for the most part although still cloudy. I went to use it again and same thing. Anyone else have this happen or have any suggestions? It's kept at room temperature.


Boils some water and let vial soak for a bit, swirl and it should go back into soultion. You may need to vent top with pin.
 
1ml of BB BenzoBenzoate/20mls will fix the problem permantntly.
I also have some U.G. cyp doing the same thing, I tried warming it and it loosened up all the crystals and turned it a bit cloudy but did not completley dissolve them. I will have to try the Benzo trick.

Where can I get Benzobenoate?

Peace
 
Top Bottom