Please Scroll Down to See Forums Below
napsgear
genezapharmateuticals
domestic-supply
puritysourcelabs
UGL OZ
UGFREAK
napsgeargenezapharmateuticals domestic-supplypuritysourcelabsUGL OZUGFREAK

Syringe / Needle Size Preferences

DocRocko

New member
What is the size/guage needle of choice when injecting?

So far in all the literature I've only seen the following; 22 guage, 1" and 1.5", 23 guage 1", 1.5" .

Is one prefered over the other? If so, why?

Thanks for your responses.
 
well i getting tired of being a pin cushion.....on my next order i will be getting 18ga to draw...and 1" 25ga & 29 Ga to shoot!!!!!
Yes gear will go thru a 29ga needle but you will need to place it in front of a hairdryer for 3-5min.

RADAR
 
There's no point (no pun intended) using anything bigger than a 25 guage 1 ".

Run the syringe under hot water for 3 secs and it goes in like silk.
 
i have used an 18 before and it wasnt as bad as i thought , but i like 23 gauge by 1.5 inch in the quads
 
there both about the same, if I have the choice I'd choose a 23 b/c it is slightly smaller. 1 inch in length also.
 
I personally go with 23 g 1 in needles for everything except glutes. I don't shoot glutes anyways though. They cause me the least discomfort and also the oil flows nicely through them.
 
tiger88 said:
i have used an 18 before and it wasnt as bad as i thought , but i like 23 gauge by 1.5 inch in the quads

Damn Bro 18g? What was it 10W30? I use a 1.5in 22g
for almost everything easy to draw and easy to dispense.
I have used 25g for winny water.
 
Nelson Montana said:
There's no point (no pun intended) using anything bigger than a 25 guage 1 ".

Run the syringe under hot water for 3 secs and it goes in like silk.

heat the needle before you draw for the injection? or after you draw and are ready to shoot?
 
Top Bottom