Should I heat this Suspension or what?

[Slyder190]

I'm having problems getting my Suspension through a 23g pin!!! Very odd as Syrus products have always been great with this exception. I will e-mail the man to talk with him about it. Anyway, Should I heat it? If so, how do I go about doing it? It's supposed to be micronized, but the shoot are barely happening? I'm assuming (and hoping) it is water-based. Not sure if I can heat it a water based compound. Any help is greatly appreciated.

 

[drrman]

heating it likely isn't going to change the size of the suspension particle bro. you can try it though

 

[newbie210]

I'm having problems getting my Suspension through a 23g pin!!! Very odd as Syrus products have always been great with this exception. I will e-mail the man to talk with him about it. Anyway, Should I heat it? If so, how do I go about doing it? It's supposed to be micronized, but the shoot are barely happening? I'm assuming (and hoping) it is water-based. Not sure if I can heat it a water based compound. Any help is greatly appreciated.

I wold like to know as well, I'm having the same problem with a 22 gauge

 

[1500]

yeah bro, unfortunetly heating wont work. the powder wasnt micronized well enough it seems like. probably just a bad batch.

 

[bbkingpin]

I've been successful by diluting it (LSP) with bac water but shooting with a 20g.

 

[newbie210]

I've been successful by diluting it (LSP) with bac water but shooting with a 20g.

right now all I have is 18g and 22g, 18's are a little intimidating.......

 

[bbkingpin]

right now all I have is 18g and 22g, 18's are a little intimidating.......

18 is way too big. You might need stitches to stop the bleeding. I use 18g for drawing from vial, but even for that purpose, it puts such a "wide" gaping hole in the rubber top of vial that often the oil begins to leak out around the 18g "pin" ("spike" or "spear" is a better word for it).