Please Scroll Down to See Forums Below
napsgear
genezapharmateuticals
domestic-supply
puritysourcelabs
UGL OZ
UGFREAK
napsgeargenezapharmateuticals domestic-supplypuritysourcelabsUGL OZUGFREAK

Quad Injection w/ 1.5" Pin?

XXXGod

New member
Hey bros,

I need a quick bit of advice. I just started my first cycle of Fina @ 50mg ED. Needless to say my ass is a little too sore to just do glute injections. In all previous cycles I have just used my glutes. I only have 22g 1.5" pins and was wondering if thes will work fine for quads or if it will be too deep? Any other advice on quad injections would be appreciated also, as I am about to inject in an hour or 2. Thanks in advance for the advice.

-X
 
Thanks for the input. My buddy has a few 25g 1.5" pins that he uses for his shoulders. I could probably snag a few from him. Thanks again! Any other tips for first time quad injections? Where to aim, etc.?
 
Inject about half way between your hip and knee on almost the outer edge of your thigh. If you look at your thigh, it should be about the thickest part of your thigh. Also, 1.5 will be ok, do as Huck said just don't go in all the way. I used 23g 1.5" last cycle with no problems.
 
... Just injected with 25g 1.5"... a little uncomfortable (I think because I was moving a little), but other than that it went just fine. I left the needle out about .25". Thanks for the help!
 
Hey just just 1/2" off the plastic needle cover and use it as a stop. It works perfert. I've done that many times. 1.5" is too deep for quads, at least for me. Go with the 1" for sure
 
oubeta said:
Hey just just 1/2" off the plastic needle cover and use it as a stop. It works perfert. I've done that many times. 1.5" is too deep for quads, at least for me. Go with the 1" for sure

good idea I sometimes help needle out a bit (awkwards) the few times I did delts.
karma
 
Top Bottom