Problems with my homebrew winstrol...

[Deleted member 33117]

Any of the bros who have experience making oil-based stano (I've made it successfully in the past). I'm having difficulting getting all of the powder to suspend, even after cooking it for 30 minutes at 250 F. I'm already up to 7 cc's of ba in my solution (which I'll have to spend time cooking out later). As soon as it cools, the entire mixture crystalizes. Its currently holding 40 cc's at 250 mg/ml. Any pointers here? Later tonight I'll cook it for an hour or so and see if that helps.

 

[rjl296]

250mg/ml, isnt that a lil strong????

 

[Deleted member 33117]

Yes, it is a bit strong, but it still should not be a solid crystal once it cools. Do you homebrew?

 

[Mulk]

I am a noobie and have never done a winsrol hombrew, sorry, wish I could help. Been reading a lot of your posts bro, hope you get the help you need. Thanks for all the info and good luck.

 

[Mythicalbeing]

You had 10gs? Sounds to me like there was more....use basskillers formula? http://www.basskilleronline.com/winny_oil.html

 

[rjl296]

Yes, it is a bit strong, but it still should not be a solid crystal once it cools. Do you homebrew?

yah, i make my gear too.
i hate winny, so i dont know too much about it LOL
id just lower the conc. myself
esp if you cant even get the powder to suspend w/ high heat and a super high BA conc.
that hurts just reading it LOL
what conc. have you made in the past ??

 

[Deleted member 33117]

I've got it under control now though, but if I let it cool to room tempurate a couple of small crystal reform, unfortunately. However 5 minutes in a hot water bath (just short of boiling) they redisolve for 24 hours or so. Perhaps I need more ba? In any event the shots are painful. They hurt for 2 days after injecting (they don't start until the next morning). Is it possible that my stano is recrystalizing a bit insite the muscle where its injected, and this could be causing the pain?

 

[Nucman]

I've only done it at 100mg/ml, and that was a chore. 250mg/ml, at 17.5% BA, yeeeeooooowww. I'll bet they hurt. If you need to go that high, use a combo of pg, ba, and peg200. It hurts a lot less.

 

[Deleted member 33117]

nucman, I've got it down to 100 mg/ml now, and baked it at 250 for over an hour to reduce the ba content. I'm mixing with masterone and prop in the same shot right now, and it is definately painful, more so than previous injections that I remember.