Problems after Baking

[tsuwr927]

So i have Xcell Labs gear. Test E and Eq. I was three weeks into a cycle and the shots were still hurting like a bitch. After every 2cc shot I would have a painful lump for the next week or so. Anyone else have any problems with Xcell? anyways, i decided to bake both vials. Since then I've noticed that the rubber stoppers are much harder to get the needle through. Also after I draw and pull the needle out a little of the oil comes out of the vial and pools on top. I'm guessing becuase of the pressure? i guess over the course of the cyle i might lose 1 ml maybe so its more annoying than anything. Just wondering if this has happened to anyone else.

 

[hyp1]

when you baked your gear did you insert a needle in the stopper(but barely out of the oil itself) to relieve the pressure while you baked it?if not that's something you should do...otherwise a shitload of pressure can build up.

I've baked my gear quite a few times and never had a problem.

 

[tsuwr927]

yea i did. i meant the pressure from injecting air when i'm going to draw.