Please Scroll Down to See Forums Below 
I've tried to make this injectable twice now with terrible results. To elaborate, the powder, when added to hot water, immediately turns into a "jelly like" substance that will not filter at all (Zap cap filter and hand pump at 800 psi)
I have tried it at 500mg/ml solutions and 100 mg/ml solutions with nothing even attempting to filter through.
The initial process was simply adding the powder slowly to very hot water and mixing. When it became seriously lumpy and thick it was heated at 200 degrees for 10 min at a time in the oven then stirred again. After the 500mg/ml formula failed, I again tried with 100 mg/ml thinking that it was just too concentrated the first time- wrong.
So, this obviously needs some type of “Pre-solvent” to get through it the .22 filters and that is where I have no idea what/how to use. How would you do it to get the 500 mg/ml (250 ml bottles) dosages?
I have tried it at 500mg/ml solutions and 100 mg/ml solutions with nothing even attempting to filter through.
The initial process was simply adding the powder slowly to very hot water and mixing. When it became seriously lumpy and thick it was heated at 200 degrees for 10 min at a time in the oven then stirred again. After the 500mg/ml formula failed, I again tried with 100 mg/ml thinking that it was just too concentrated the first time- wrong.
So, this obviously needs some type of “Pre-solvent” to get through it the .22 filters and that is where I have no idea what/how to use. How would you do it to get the 500 mg/ml (250 ml bottles) dosages?
