Please Scroll Down to See Forums Below
napsgear
genezapharmateuticals
domestic-supply
puritysourcelabs
UGL OZ
UGFREAK
napsgeargenezapharmateuticals domestic-supplypuritysourcelabsUGL OZUGFREAK

opinion - use/throw out

overrx

New member
ok ive been planning this cycle for a while and i dont have any more money left, its a fina + winny cycle...well today i bought some insulin needles for the fina. i did everything according to procedure, alcoholed vial and injection site, then i aspirated, stuck the needle in. then when i tried to draw out some of the fina, it came up way to easy, so i pushed the plunger done and did it again, again nothing came up. i repeated this, then i withdrew the needle from the vial and reinserted it. mind you i did this with two needles, both sterile, but i only cleaned the vial once (but it didnt touch anything else). i eventually got a few cc's but not enough so i squirted them back in the jar. finally i gave up figuring the pins were too short or something cause no solution was coming up. then i looked more carefully at the bottle and noticed it had 3 or 4 small bubbles that were oil colored only darker. so i shook the bottle and put it away.
just now i took it out to see what happened, still the small bubbles, and the solution isnt clear(i cant remember if it ever was i just know not it isnt)

do u think its stil safe to use the fina considering i didnt really contaiminate anything, but i really dont know what the orangish/oil colored bubbles are...moreover all i have is winny and its all i can afford, so if i cant use the fina, i can only do a winny only cycle which kinda blows.

any and all opinions/advice are welcome...thanks
 
Ummm...

I could be wrong (not likely), but fina is oil based no? Tell ya what go into the kitchen and try to draw up some cooking oil with an insulin pin. Should get the same results. You need to get some 22g, 23g by 1" or even a 20 to draw up your fina. I wouldn't recommend shooting with a 20 though.
Now a question for you. How did you expexct to get into muscle tissue using a slin pin? Or did you plan on doing SubQ?

Asta
 
someone from this board said trying using insulin pins cause of the pressure in 1cc, anyway so what should i do, throw it out or use it?
 
Ok, so you tried to draw up the fina with the insulin pins, correct? If so, I am not surprised you did not get much fina.

I think the fina is fine. Next time, however, use a bigger gauge to draw up with. I recommend something like an 18-20g needle. Remember, when you are pulling the juice outta the vial, there isn't much pressure that you are able to apply. Certainly nowhere near the pressure you can get with your insulin pin.

So, draw with a larger needle, even a 23g will do, it will just take awhile. Then, squirt it into the insulin pin, and shoot away.
 
overrx said:
thanks, justr wanted to make sure i wasnt gonna grow a third nipple injecinting this stuff

Whoa, hold on a minute, Buster. I never said you were NOT going to grow a third nipple, now did I? ;)

I just said it was ok for YOU to shoot it, lol.
 
Your injection can be with a small gauge needle, but you need to withdraw from the vial with a large (18g) needle.

And don't knock it you may like the third nipple.
 
Top Bottom