One shot or two??

[Big_Joe]

I am going to be starting a new cycle and there will be a lot of oil shooting with each injection.

My question is would it be better to do two injections, one on each side, each time or just use a 5ml spike and do it all at once.

The reason I wonder about this is it's the surface layer that the enzymes brake off the esters and make the compounds available. If when you inject and you get a big bubble of oil it will take longer then if you had two smaller bubbles. But if when you inject and the oil just slips between the muscle fibers it wiuldn't make a fifference because the surface area to volume would be a very smal ratio.

So what do you all think?

 

[the elite addict]

split it up. 5ml in one shot? are u nuts? I never go over 2.5

 

[Bigpimpin10]

ive ne ver gone over 3... and 3 still hurts lol...yeah split it up bro..and itll take the blood level stable as well.

 

[access]

5 mls at a time. Definately don't do that in one injection. How do you get to 5mls anyway? What is in that 5mls?

 

[sweed]

haha ya what are you taking?? must be low concentration gear.

 

[Cardinal Slin]

Just split it up and do it twice weekly rather than doing it all in one shot/two shots on the same day

 

[nydj66]

If what you're injecting is longer ester, longer half-life gear, then it distributes itself throughout your adipose tissue (body-wide) and then slowly enters the bloodstream over time. Esterase is in the blood and that is where deesterification takes place.

However, 5ml in one injection site would be way painful and for that reason alone I would split the injection between two different sites.

 

[got2getripped]

3cc is as high as I'd ever go for one inject and even then I avoid it cause it feels like a bit much. I always split stuff like that to 2 times a week or what not.

 

[housemusik83]

2ccs for me is a lot.... id split it. whats are we talking about anyways?

 

[HAYEZ]

3ml is fine to shoot...not sure why you guys are getting pain...bad injection technique?
glutes id go 3 , delts 2 , quads 2, pecs i just started and havnt gone past 1 ml,
mon and thursdays i do 4.5 ml and just split it between delt and glute

 

[littleb]

shit bro what is the mg/cc ratio,,, 50-100?? i would buy stronger,, i can deal with the pain dont like all the oil...

 

[RADAR]

Joe......I never go over 3 and thats only in the delts and glutes, I didn't realize you were planning 5 mils, logic is the smaller the injection the more quickly it will be asorbed, and 5 mils is gonna leave Quite a lump regardless where you shoot it, Def break it up into 2.

RADAR

 

[ALIN]

I am going to be starting a new cycle and there will be a lot of oil shooting with each injection.

My question is would it be better to do two injections, one on each side, each time or just use a 5ml spike and do it all at once.

The reason I wonder about this is it's the surface layer that the enzymes brake off the esters and make the compounds available. If when you inject and you get a big bubble of oil it will take longer then if you had two smaller bubbles. But if when you inject and the oil just slips between the muscle fibers it wiuldn't make a fifference because the surface area to volume would be a very smal ratio.

So what do you all think?

for 5ml i would split in 2 injects

 

[access]

I would still like to know exactly what makes up that 5mls.

 

[HAYEZ]

I would still like to know exactly what makes up that 5mls.

prob bout 2 grams give or take