Please Scroll Down to See Forums Below
NPP recipe?
- Thread starter DJ_UFO
- Start date
OK this is my recipe for NPP. Just cut down for smaller amounts.
Items Needed for a 10 gram conversion:
-10 grams Testosterone Propionate, Tren Acetate, or Boldenone Propionate, NPP
-2.0ml benzyl alcohol (2% BA)
-20.0ml benzyl benzoate (20% BB)
-70.0ml oil
-Syringes 3cc & 5cc or 10cc
-20 gauge needles
-Mixing vial (or preferably beaker)
-Sterile vial
-Sterile syringe filter
1) Weigh out 10 grams of hormone into mixing vial or beaker.
2) Add benzyl alcohol, BB and 65.0cc of oil. (This will leave 5cc oil for later.)
3) Place on stovetop (electric stove) or frying pan (gas stove) on medium high heat.
4) Swirl and heat until soultion is completely homogeneous and clear. NO hormone "swirls" , crystals, or visible separation should be left.
5) Place 20g needle in sterile vial and attach syringe filter.
6) Place another needle through stopper to releave pressure
7) Draw out hormone solution with 5 or 10cc syringe and run it through the syringe filter until all solution is filtered.
8) Run the addition 5cc of saved oil from step 2 through syringe filter to purge.
This conversion results in 100ml - 100mg/ml sterile solution for injection.
Items Needed for a 10 gram conversion:
-10 grams Testosterone Propionate, Tren Acetate, or Boldenone Propionate, NPP
-2.0ml benzyl alcohol (2% BA)
-20.0ml benzyl benzoate (20% BB)
-70.0ml oil
-Syringes 3cc & 5cc or 10cc
-20 gauge needles
-Mixing vial (or preferably beaker)
-Sterile vial
-Sterile syringe filter
1) Weigh out 10 grams of hormone into mixing vial or beaker.
2) Add benzyl alcohol, BB and 65.0cc of oil. (This will leave 5cc oil for later.)
3) Place on stovetop (electric stove) or frying pan (gas stove) on medium high heat.
4) Swirl and heat until soultion is completely homogeneous and clear. NO hormone "swirls" , crystals, or visible separation should be left.
5) Place 20g needle in sterile vial and attach syringe filter.
6) Place another needle through stopper to releave pressure
7) Draw out hormone solution with 5 or 10cc syringe and run it through the syringe filter until all solution is filtered.
8) Run the addition 5cc of saved oil from step 2 through syringe filter to purge.
This conversion results in 100ml - 100mg/ml sterile solution for injection.
Last edited:
perronuchy
New member
Anyone has a 200mg/ml ? i researched over the internet and i only found 100mg/ml 
Anyone has a 200mg/ml ? i researched over the internet and i only found 100mg/ml
Painful...not sure if it's better using EO or if it stays suspended it at that concentration
Similar threads
