Melting Points

[cswole]

Would appreciate it All I could find at <100 was just the stirrer without the hotplate

 

[buffsthestuff]

i found a couple that have both for under 100 ill pm you

 

[cswole]

Appreciate it =)

 

[sportmuaythai]

You wont have to worry about going over these temps because the time it takes to disolve into solution while being heated and stirred isnt long enough to reach these temps for the most part and I use a pan with boiling water to disolve the powders while in the ba/bb and the max temp of boiling water on the stove with nothing added is like 100c which isnt close to the melting point of the powders I have you have to add oil or another substance to the water to get it to go above 100c

I beg to be in contrary. You need to know the melting points if you're doing blend. If you're making blend of tren and EQ, you should not mix raw materials together. Tren has a higher melting point, and by heating to melt tren, you can degrade the EQ. You should dissolve tren first, let it cool to room temp before adding EQ, then slowly reheat to bring mixture to complete solution.