loading syringe from amp

[drgoodbody]

Oye.....

Ulter is a great guy for answering that

Damn, this thread makes my head hurt....

DrG

 

[tee]

I can't believe I am going to answer this.

You need two needles so you don't stick yourself with a dull pin. The first needle should be as 18 gauge "drawing" needle. Take your needle off your syringe and put on a "drawing needle. Don't let the one that was on there touch anything. Hold it between two fingers while you put the drawing needle on the syringe. Now take the cap off the drawing needle and put it in the amp (I will assume you've opened the amp by this point) and suck up the oil into the syringe. Then take the drawing needle off and put the original needle back on.

Ulter,

You didn't say how to open the amp. Will it work to place a table saw on its side and cut so the fluid won't run out? lol

 

[Badatta2d]

Geez with all those shiny stars I would think George himself, would hit you bro.

 

[Gambler]

You should put your gear back in the drawer for a couple of years while you "fine-tune" your knowledge of AAS use.

 

[argent]

Ulter,

You didn't say how to open the amp. Will it work to place a table saw on its side and cut so the fluid won't run out? lol

Actually a sawzall will work better.